BQ Easy Go & Ender 3

Separation ring mounted

I’m quite happy with BQ Easy Go PLA filament. I have been using it during these last days and had no problem at all, but it is also true that I read some comments in Amazon before using it and there is an issue with this filament and Creality Ender 3 printers:

There is a big logo in one of the sides of the coil. It may occur that this logo gets stuck in the coil guide of the Ender 3.

BQ Logo in coil side
BQ Logo in coil side

The easiest solution I found for this was printing a ring to prevent the coil from getting too close to the printer guide.

Separation ring
Separation ring
Separation ring mounted
Separation ring mounted

You can find the ring files in Security ring for Ender 3 and BQ filament at Thingiverse.

 

Leave a Reply

Your email address will not be published.