Claudio, the box

The box of the prototype consists of 4 pieces designed with Freecad to be 3D printed.

I used PLA, heating the bed up to 60ºC and the nozzle to 200ºC.

Claudio Front side
Frontside (from inside view)
Base (from inside view)
Cover (upside down)
Backside (from inside view)

Mounting is very simple and though the design includes eight blocks at the corners to allow screwing I found it wasn’t necessary as the pieces stay together after mounting due to pressure.

The four ‘columns’ at the base allow mounting a PCB over them and some wires can pass down it.

Some more pictures follow below:

Buzzer placement

DHT11 placement

 

MicroUSB hole
Mounted box

 

Leave a Reply

Your email address will not be published.